Today I was close to lost my beater because the bracelet fell in two parts.
When I look at the watch I suppose
it's time fore some cleaning of my beter. LOL
So I start to pull off the bracelet
I guess a cleaning will be in place.
So I have to open it up.
The movement is pretty clean and runs like a charm.
So lets get into it.
I start with the crown.
Then I go for the movement
Turn it around in the case
And there we go. Nice and crisp dial.
The bezel
Some dirt under it too
Into the bath
Set it on 9 minutes
Can't see the parts after 3 minutes
Now we talking
The case is still doing fine
From the start it was a fluted WG bezel, now it's close the a smooth YG.
Now I have to take care of the clasp
I start to get it back where it should be
Not bad
Then I will put on a new crystal
Damn I haven't plan for this and I have run out of DJ crystals at the moment. So I have to take one of the used ones I still have.
And some polish
And there we go.
Now it can serve me for some time again
A few days later there was some parts arriving from Geneva.
So I have to do some more work with the watch.
The pin have some traces of use.
A little adjustment.
There we go.